#1. How to setup a Hot Water Heater
How to setup a Hot Water Heater
Hooking up a hot water heater is one of the more tasteless home mend jobs and is easy to learn. But, be sure to read all of the directions before beginning. You do not want to find that you are stuck with no hot water.
How to setup a Hot Water Heater
Obviously, the first thing you must do is disconnect and remove the old hot water heater. Be careful, though, as it is still full of hot water. Turn off your gas or electricity, whichever is linked to the water heater. You then need to drain the water from the old heater. A drain valve should be on the heater for this purpose. For a gas heater, cut off the vent pipe from the draft hood which should life off after you remove the sheet metal screw keeping it. Confirm that the pilot light is out, disconnect the gas line at the heater and cap it.
You will next need to remove the water heater from the pipes, but be rigorous since the water pipes may still have hot water in them which is still hot enough to burn you. You may need to use some pipe wrenches to remove them, but there should not be many pipes linked so this step should take miniature time or effort. Once completed, you can remove the water heater and arrange of it. Keep in mind, though, that may local and state laws have restrictions on disposing of hot water heaters. Check with the local authorities for any disposal requirements in your area.
It is now time to install the new unit. Do not drag the new unit into your home as there are brittle parts inside that can be damaged if it is jolted too much. Try using a dolly to converyance it into your home. Once moved, position the new heater so the piles can no ifs ands or buts reach it. If you are using gas, be rigorous that the gas pipe can reach no ifs ands or buts to preclude any gas leaks.
You now need to connect the hot and cold water, which is a uncomplicated process. connect the new water heater to the same connections as the old one, and connect the third pipe to the main water line. If you are confused or there are no connections, refer to the user manual. Connecting the pipes is the most tasteless mistake made while installation. You can test it by turning on the water. If the cold water turns hot and your hot water never warms, you will need to switch the pipes.
Next, you must search the relief valve on the new hot water heater. The temperature and pressure relief valve is an leading part of the system, as it releases excess heat and pressure automatically so that the unit does not explode. This is a requisite and leading protection feature that is standard on all units. Finally, connect the new hot water heater to the power. connect it whether to the gas line or the electricity so the water can be heated. The education hand-operated can justify how to do this.
share the Facebook Twitter Like Tweet. Can you share How to setup a Hot Water Heater.
0 comments:
Post a Comment